1950 Ford 8N serial # 318100

Our First Lawnmower


This tractor was purchased in the fall of '94. It was completely disassembled and rebuilt from the ground up. It's pretty much original except for a conversion to a 12 volt electrical system with Delco alternator. The rear wheels are 12x24 with 14.9x24 Armstrong turf tires which gives about the same height as the original ag tires but a lot more width. The front end has '36 Ford car hubs with some old stock car wheels and G78 car tires to be easy on the grass during sharp turns. It has a Monroe E-Z ride seat (original accessory), footfeed pedal, pto shifter extension, a cyclone air cleaner, Pertronix electronic ignition, and a few other refinements. The Woods belly mower does a beautiful job finish cutting the grass. We've got 1200+ hours of mowing time on this tractor since it was finished in the summer of '95 with no problems of any kind.


Our mower

One starter drive was the only part to fail on this tractor in almost 13 years of mowing



Rear

It takes some BIG turf tires to provide the traction needed to mow our steep hills



Right side

The Woods model L503 belly mower does an excellent job



Left side

Left side view



Mower

Just like driving a big Cub Cadet....



Hill climbing

Mowing up a hill (that's steeper than it looks) is easy
for the 8N. But don't try this on wet grass. Trust me.


In 2006 we started building a new lawnmower tractor. It was
completed in 2007 and the 8N has been retired from it's mowing duties.
To check out the new lawnmower tractor [Click Here]